I have rebuilt and painted the engine from my CJ-5 project, and I'd like to get the bell housing spacer plate and inspection cover ready. I see...
That is certainly tempting... Does anyone know what would be involved in restoring the fiberglass to looking like new? If there is no fiberglass...
I was able to get them separated, they had the crimps like the earlier Jeeps. Now to figure out how to find new shaft seals. Since my (early) 74...
Looking to buy a TankTop fiberglass hardtop and doors for a pre-1976 CJ-5.
Does anyone know how to get this dust shield off? Both the front and rear driveshafts feel quite solid at the end of travel, neither of them...
The original rear crossmember on my '74 had the same circular areas.
I was removing the Dana 44 rear driveshaft on my '74 CJ-5, and can't seem to separate the halves. I don't want to damage it by being too forceful...
I ended up going with Motor Coater by KBS Coatings in '73-81 AMC Engine Blue'. Attached is a photo of the motor, taken the day after I painted it.
Thank you all for the advice, I will be reusing the head bolts.
I went out to the shop and measured the head bolts, they are as follows: Quantity 10: 1/2" diameter, 3-3/4" long from top of head Quantity 3:...
Unfortunately not, there should be 13 bolts total, with 3 of them being slightly shorter than the rest and with threaded studs above the bolt head...
I'm having a tough time finding new head bolts for the AMC 4.2L in my '74 CJ‐5. Does anyone know where I can order some? I would like to...
Separate names with a comma.