Yup! hoping its a better solution than the transmission hanging down to low. Plan on a double cardan joint and angle the pinion up towards the...
Got the motor and trans bolted together [img]IMG_20210225_121734 by Sam Prankerd, on Flickr Dropped the whole lot into the frame to see if things...
Thank you all! new front crossmember burned in [IMG]IMG_20210121_161210 by Sam Prankerd, on Flickr had to remove the factory steering/Radiator...
Hello, great forum some inspirational builds and some seriously clever folk in here. A lot of forums have dried up but seems like you guys are...
IMG_20210103_163458 Input shaft stick out is 6.5 inches and case total length is about 11 7/8
So I've finally got the transmission on my work bench. Cover is off and did some counting. The transmission seems to have a 6.3 approx 1st gear....
That's crazy! I've scoured the net and found nothing until yours! So it's a Canadian made t98? Perhaps a conversion company bought up some...
Thanks Twin2. Same adapters output shaft for t98?
Thanks again. The knowledge on this forum Is astounding! The transmission is currently adapted to a Chevy V8, and I plan to use either the V8 or a...
Yes Chevy V8. The bell housing has the mounts and there is no transmission crossmember from what I can see?
Haha I don't know. I assume it has been swapped in at some point.
No numbers like those on the side unfortunately just these received_2098479406942375 received_402653004080580
Not sure if they work?
received_2726750584206516 received_4017445588284037 received_1228878454148683
Separate names with a comma.
