looking awesome. Just throw a clear coat over the slides to slow down any rust.
I agree on how they all have their own personality. Yes, the procedure was helpful. I had actually seen very similar procedures posted on Gearhead...
Funny how when you're cruising along with the install you think the grounds are good, but when you go back and look at them again you say "huh,...
Well, a small update to report. I will post the log at Gearhead, which isn't a great log because I didn't have all the things turned off that...
you bet. I didn't record much yesterday. Did a lot of just toying with the tune and making small adjustments on the fly to see what would happen....
Noted on the code 51. I hard soldered the the adapter into the ECU and I have not been getting that code. I think it did have a loose connection....
Looks good man! sometimes those little fixes really help in the overall scheme!
Hey Ed, I invested in an Ostrich 2.0 emulator for quicker tuning. I got tired of taking the chip in and out. Once I have the tune dialed in, I...
Thanks Ed, I have been going through all the different scalars and started noticing there are adders to the VE/spark table under different...
I appreciate the input. I will do some more research and digging. I added a little more information to my previous post before I realized you had...
Thanks for the explanation, Fireball. Do you know if my base timing should be set at 6° BTDC at the crank, or should it be left at 0°? I will...
Hey Ed, yes I switched the BIN to ASDW - The other tune didn't seem to run as well. The ASDW says it s for 87 R-V Truck 5.7L TBI 4 Spd Manual....
Couple of photos of the passenger side exhaust going over the T-case. Took some S-bends cut in half and re-welded to slightly different angles to...
I still had to route over/around the T-case.. I will try to get a photo of my routing
Got VSS installed - I went the Dakota Digital route for future modification flexibility. The sensor is an 8K PPR and the Dakota Digital unit...
Separate names with a comma.