Oil temp gauges are normally associated with air cooled engines. I've never heard of one for a liquid cooled engine. I think the water temp gauge...
Some issues that come to mind If you're talking back seat, you will need the support brackets and hardware. Those are unique to M38a1 but easily...
Nice work! I had to do some similar engineering when I changed the wheel style on my wrangler. Speaking of boobs, my wife calls the front turn...
My Jeep had aftermarket replacement axle shafts. They weren't even provisioned with a groove for a snap ring. Weren't the snap rings a holdover...
I use the red stuff in a tube from Tractor Supply. It's like Frank's Red Hot, I put that $#!t on everything. I wash my bearings when I repack...
It sure sounds to me like your commute just isn't long enough to warm the engine. My Dauntless doesn't usually register on the temp senser until a...
My 67 was set up with factory manifolds and mufflers outside the frame under the doors exiting in front of rear wheels. I did not like it. Felt...
Looking for a set of side steps for a CJ. Wanted to see if I can source an original set before I buy Omix. I don't mind if they need repair,...
I don't think that's how the one I worked with was set up. Mine has 3 knobs. Heat / cold which works the door in the heater core, defrost which...
I have the missing cowl side piece. If you need it send me a PM
I might have one of the missing piece but won't be able to check until Monday
Separate names with a comma.
