Thanks a lot Tim. I will see if I can get them here at a reasonable cost. I get what you are saying about the shocks. I don't want to treat them...
Hi Tim. Strange as it sounds but the originals were 12front and 7rear. During the rebuild I could see that it is still the original bushings, and...
Good afternoon to you all! It,s been a long while since I've posted anything on the forum, but my forgotten password is sorted out now. I'm...
Well, that is the one thing I'm not sure about. I have asked the shop who overhauled the motor to pay attention to the parts going back in the...
Thanks for the info. I will check all of the above. Can any damage occur with the clatter? Yes, that "NOTE TO SELF" is duly noted! Very cross...
I,ve got a noisy lifter after my rebuild. The engine was completely overhauled except for the cam and hydraulic lifters, and it's running like a...
I envy you pathkiller! I don't get to Namibia and Botswana often enough. In December I'm doing a desert trip again from Luderitz to Walishbay....
O.K. Here are the last couple of pics to the point where I'm at now. I really started to have some fun, as everything was coming together...
All that I can say is WOW!!!! What a drive. I love this Jeep to bits, and what a rewarding experience to have done a project like this!!! I will...
I installed the engine, drivetrain, exhaust and all of the brake and fuel lines first. Basically the whole chassis to run it in gear on jack...
Any news on that rollbar hight?
No problem, thanks!
I need some measurements for my rollbar. I just need the total height from the floor level to the top of the rollbar. Appreciated thanks,...
Separate names with a comma.