If its a Novak adapter? they told me I didnt need the gasket as a shim. When I did a T18/T19 in a 74. I had issues getting it to seal up! I had to...
Why would you want to run a different trany/transfercase setup? Just a question!
Yep.. M20/21
I have seen 4.0's I6's in short nose CJ's The best setup I have seen is.. the grill was swapped for a DJ grill and the inner part was cut out.....
What oil are you using!! I have had many richmond brand box lockers in rears and fronts.. I decided once to use heavy gear oil because of the...
http://www.earlycj5.com/forums/showthread.php?t=73856&highlight=trany+cj5 I used a fully syncro 5-1 T19 from a Ford Bronco.. above is my build...
I did not support the front! I have never had to if you use a piece of 1/4 flat on the inside the firewall.. My pedals are mounted to the left of...
I had to modify them! I was actually looking for a set from a XJ but the cost was too much! I paid ten bucks for these.. I had to cut some off of...
it has been fun.. Research has actually taken more time than actually building it! My tub isn't that great but its worthy of using untill I find...
I used undercoat and bedliner from Duplicolor (Summitracing), under the tub, firewall and inside the tub.. painted the frame and painted the...
I picked up the hood and a windshield frame.. I found the tilt column from a 1975 wagoneer. These are just a cheep set of tires and wheels so it...
SO I have had many jeep from 47 to a 2002.. and many in between. I like the older iron. Just something about it! This one is a little different.....
My 1 1/4 shaft t-case does have the 29 tooth input gear.. Thanks! Good info!
Thank you! That is not enough change in ratio to worry about! I was under the undersanding it was a wider gap than that! Yes one is the 11/4 and...
Separate names with a comma.