What is the thing int the middle of the cable? Should it be there? If so where does it attach?
About what is the diameter of the hole?
Are your postal fenders fiberglass? I'm looking at a set off a 1984.
Did you try this would the fenders fit an early cj5?
thanks that's great
Can some one post a picture of the clutch linkage assembled. There is some kind of attachment in the middle of the cable I can not figure out...
Thanks Focker. There is not a hole there on mine, can you get me a close up picture on where the hold should be so I can cut one? Thanks
Attached is the transmission cover that came with my jeep project. I don't think it is correct for a single stick transfer. Can someone show me...
if you look here on page 6 Dana calls it a case http://www2.dana.com/pdf/AXIP-0076.PDF if you look here Summit calls it a carrier...
Some people call it a case others a carrier or ring gear carrier. The bearing that go on the end of it are called carrier bearings.
When did the windshields change to having the brackets on the bottom to having them on the front? Can a tub take either with the correct hinges?
Thanks Uncle VIn. Just what I was looking for.
Separate names with a comma.
