The sealing surface of the yoke looks great, no grooves at all. Don't have the paper seal mentioned and can't remember if I pulled one out on...
Been attempting to seal my Dana 18 for some time now, and have only ended up with puddles on the floor and ruined rear output seals. When I first...
My decison to go with Herm's kit was because I could get a box mount from him which gave me a starting point. My '58 sports a 283 chevy with a...
If you've still got the battery and starter hooked up, put the plugs back in and give her a quick crank. Its best to place a few of the head bolts...
For my needs, the 283 in my '58 gives me everything I want. It was swapped in over 25 years ago still runs like a top. Since just a few months...
When I replaced my bushing a few months back, I didn't need to heat the spindle at all. Granted, mine was the old spindles, but I just left the...
dang it. try this one maybe? http://community.webshots.com/user/mjstrine04
Just finished up my SM420 swap last week using the AA adapter and ran into the same problem. My engine wasn't going to move other than the angle...
Hey Lynn, we must have ordered our shafts the same day 'cause mine just came yesterday as well. Very happy with what came and everything should...
what about the grease hole in the end of the shaft. under compression grease will squirt out, shouldn't it let water out too?
I've heard the proper way to install a driveshaft is with the slip-end up-hill at the t-case, which I have always done. What are some reasons...
Hey Lynn, need to get my rear shaft cut down and the front retubed for the SM420 swap. I was actually gonna call York Mack this afternoon to get...
Hey Jim, what kind of mount are you using to go to the AA adapter? Im in the middle of the swap too and used the AA made mount. Two, 1 inch thick...
Separate names with a comma.
