Got it...thanks Sink...... I'llbe checking in more often now that the project has resumed....
Thanks for the quick reply.... Yes, I am pulling everything and doing a complete. I did see a good write up on pulling the wheel, none of...
Well, I haven't been here in while.....I am tearing down my CJ6 for restoration. I am having problem pulling the steering wheel/shaft. 1) I...
Ok...I know this is getting old for you guys but I really appreciate your help. I checked and I am not out 180. Bear in mind my Dist Cap has...
John do you think the PO had the dist. off 180deg? I would appear that #1 would need to move around to 3:00-4:00 position to move the timing...
Thanks Hippo I have heard that before. I will do as you said though with the 264 set up. Its running............ Ok, put everything back...
Good ideas guys Condensor: I am familair with problems with these. Typically a condesor will not effect cranking. Hard cranking and shut off...
I check continuity there but did not check ohms. I thought this and examined the wire but I will review it again. I didn't think to check ohms...
+ side coil 8.5-9v Tried the Jumper to the coil, no change. Keep um coming Barry :?
Dwell set at 30-31 and no Variance at different RPMs (when running).
John, I did check my light last night. It seems fine. I got a Delco ditributor cap and it didn't fit :roll: The plate inside the...
My timing really isn't the issue I don't think. I can't get consistant fire to check timing. I have something wrong in the ignition curcuit....
Ok, I made a diagrham of the ignition curcuit with the correct color wires etc. I actually pulled the harness, checked all wires and replaced some...
Separate names with a comma.