I got my T14 and bearing retainer from Herm over 10 years ago. Still working great. Not sure if the bearing retainers are the same, but Herm...
Image by Rob C posted Nov 24, 2015 at 10:11 PM The "Nomad" with her new paint. 66 CJ5, 225.
Oh, got you. Guess I should have read your original post closer. Good luck. I'll be following this as I really don't like the fenderwell headers.
I have a set of Hedman headers on my 66 with Herm's steering kit and it clears fine. It's a little close but I was able to make it work. I'm out...
Thanks. Ive had no luck finding a boot like the one pictured and the part numbers above for the single stick. When I got the jeep it had a...
My 66 has the single shifter for the transfer case. It is stock.
I did Herm's conversion while I had the body off the frame. Easy to install but would recommend that you get his banjo fitting kit too. Makes...
Try Double D Fab. He makes all years and can even customize one if needed. I bought one from him and it is very well made and fit perfectly....
Very nice! I'm getting close to taking the plunge with the Herm kit. What kind of work did you have to do to the stock steering shaft. Did you...
IIRC, you do not need to cut the axle shafts when using the Warn hubs. I have a 66 with a D27 and I did not have to do any mods. I'm pretty sure...
The set from Quadratec comes with the fittings that you need. If you order lines individually from a place like classic tube then you'll have to...
I may be wrong, but I think the older ones had safety issues and were not DOT approved. Supposedly the new ones are. But, I'm actually thinking...
Separate names with a comma.