1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

73 cj5's Recent Activity

  1. 73 cj5 liked Johns1967CJ5's post in the thread Never Doing Another Project !!.

    Finally got the weather strip on [IMG] And the bumper . Need to get some carriage bolts [IMG] [IMG] Some frame painting...

    Feb 20, 2019 at 10:41 PM
  2. 73 cj5 replied to the thread Ted's Engine Upgrade.

    Nate if the turbo doesn't work out....:sneak::twist: [IMG]

    Feb 20, 2019 at 10:14 PM
  3. 73 cj5 replied to the thread What Did You Do To Your Jeep Today?.

    x2. I bolted my replacement engine mounts on the 2A and the hardware never failed.

    Feb 20, 2019 at 10:05 PM
  4. 73 cj5 liked millennium falcon's post in the thread Roll Bar Project..

    Today I got the other bow sorted out. [IMG] [IMG] [IMG] I'm quickly learning this is not a fun one man job... holding everything...

    Feb 20, 2019 at 10:03 PM
  5. 73 cj5 replied to the thread 3b Project.

    I've had a few thoughts about how to make these perches work. Grind down the right side of the perch until it's level came to mind....

    Feb 20, 2019 at 10:00 PM
  6. 73 cj5 liked millennium falcon's post in the thread Roll Bar Project..

    Well I finally made some progress.... [MEDIA] [img] [img] [img] [img] [img] [img] It was cold in the shop today. My toes were...

    Feb 20, 2019 at 12:27 AM
  7. 73 cj5 liked ITLKSEZ's post in the thread Varg In Jeep's Clothing.

    [IMG]

    Feb 19, 2019 at 1:36 PM
  8. 73 cj5 liked ITLKSEZ's post in the thread Varg In Jeep's Clothing.

    I had to quit for the day, but here's where I'm at. I used those wooden templates to make CAD templates from, then used them again as...

    Feb 18, 2019 at 4:23 PM
  9. 73 cj5 liked ITLKSEZ's post in the thread Varg In Jeep's Clothing.

    Think cherry is strong enough? :lol: [IMG]

    Feb 18, 2019 at 4:03 PM
  10. 73 cj5 replied to the thread Varg In Jeep's Clothing.

    See I was imagining the pedals would be close to vertical and the pads offset to the arm like a go kart.

    Feb 18, 2019 at 1:26 PM
  11. 73 cj5 liked millennium falcon's post in the thread Roll Bar Project..

    More updates [img] Working towards center [img] [img] [img] [MEDIA] [img] 56 feet of 1.5" .124 wall tubing. [img] Tub mount...

    Feb 18, 2019 at 12:44 PM
New Posts