Clicking instead of cranking should probably be diagnosed in this order: Battery state of charge Cleanliness/tightness of all connections between...
Cool. Thanks! Also, the Chilton's manual shows an electrical oil pressure gauge and the Jeep has an electric sender and harness down at the...
I've gotten most of the wiring into this CJ7, but all the emissions stuff is missing and it had been chopped on some so if anyone has a nice...
It's possible - the rear fenders both lean one direction about 1/2". Can't find obvious evidence it was ever hit, but it's not perfectly straight....
That's what I was thinking - the tub's going to have to be caddywampus on the frame ever-so-slightly to fix it.
After putting the front end on this CJ7 I've been working on, I have some alignment issues. The tub is perfectly centered over the frame and the...
Picture of the bearing/collar setup. [IMG] With the passenger shaft all the way in and the backing plate tight against the axle tube, the race...
I'm putting new wheel bearings in a '79 CJ7 with model 20 axle and one-piece axle shafts. Upon disassembly the ends of the axle shafts have been...
I bought rears for my '85 GMC from them and am happy so far, with about 18 months and 6-8,000 miles on them.
Okay, gear heads - whatcha think? To my novice eye it looks passable. Drive: [IMG] [IMG] Coast: [IMG] [IMG] Pinion: [IMG]
Separate names with a comma.