I think it will do pretty good. Its a lot heavier than the old one though. Its funny after cutting out the old floor you could roll it up like a...
yeah, the red pics are from b4 starting the body work. The body was covered in bedliner that I decided to have removed. Not just because it was...
Still needs a lot of work to look better cosmetically. While the rear sheet metal isn't as interesting as the stock version with the raised ribs,...
some more pics
I have put quite a few post in regards to the body on my jeep, so I thought that I would post my progress, Not to many pics, and really not that...
quick update: Soda Blasting on the exterior of the jeep worked well. However....After getting it done, realized that there was much more...
Thanks a lot for the help. Well, the tube is gone, didn't notice it until a few days after it was blasted. Also, the sending unit wasn't really...
Hello. I have a 1966 CJ6 that has turned into a full blown project. Right now, I have everything apart, and the body off of the frame! Not sure...
thanks again for the tips. I am going to try to save as much as possible. Realisticly, this is going to more of a trail jeep for me. So I was...
Thanks for all the tips guys. Does any body know where to buy the floor pan piece on a CJ6 that goes between the rear and the front sections? The...
hey guys...well soda blasting is working :) There is a lot of rust issues with my tub under the bed linner as I thought might be the case :(...
do you need to replace anything on the Tcase if you remove the overdrive? I am not sure if mine even works as the solenoids were not wired up....
"Won't affect street driving with the hubs unlocked" I completely forgot about this. lol :) And, currently the rear is stock, not 30 splines. I...
Separate names with a comma.
