1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by jason74

  1. jason74
    Post

    Still looking for the CJ-5...Need input on this one

    What kind of tranny and gears does it have if it can only do 55 w/ an overdrive? Sounds like it should be able to go a little faster if it has an...
    Post by: jason74, Sep 16, 2007 in forum: Early CJ5 and CJ6 Tech
  2. jason74
    Thread

    Clutch noise

    I did some searching here but couldn't find an answer. When engaging the clutch from a standstill, either in reverse or 1st, the I hear a sort of...
    Thread by: jason74, Sep 8, 2007, 0 replies, in forum: Early CJ5 and CJ6 Tech
  3. jason74
    Post

    1966 V6 Radiator Problem

    If you still have the old radiator you can take it to a local shop that repairs them. I assume it is beyond repair, but these guys usually have a...
    Post by: jason74, Aug 28, 2007 in forum: Early CJ5 and CJ6 Tech
  4. jason74
    Post

    T18 Value and Dana 20 question

    Dang!! The guy emailed me a little while ago...he sold the set up all as one. Oh well, I think I may have found another....
    Post by: jason74, Aug 27, 2007 in forum: Early CJ5 and CJ6 Tech
  5. jason74
    Post

    Darn Jeep !

    From what I've been reading 15 btdc may be too far advanced. 5-10 degrees seems to be the norm. The knock, especially under load is probably...
    Post by: jason74, Aug 26, 2007 in forum: Early CJ5 and CJ6 Tech
  6. jason74
    Post

    T18 Value and Dana 20 question

    My fault for not being clear about what I was saying. I think I get it now. Thanks for the input. If the TC ends up being a D18 I'll just...
    Post by: jason74, Aug 25, 2007 in forum: Early CJ5 and CJ6 Tech
  7. jason74
    Post

    T18 Value and Dana 20 question

    Sounds like it came out of a Jeep that had a Ford 302 V8. I have a Dana 18 and I'm trying to figure out if the overdrive will fit, or if it will...
    Post by: jason74, Aug 25, 2007 in forum: Early CJ5 and CJ6 Tech
  8. jason74
    Thread

    T18 Value and Dana 20 question

    Does anyone know the estimated value of a working T18 Borg Warner tranny? My other question is can you connect a Warn overdrive to a Dana 20...
    Thread by: jason74, Aug 24, 2007, 9 replies, in forum: Early CJ5 and CJ6 Tech
  9. jason74
    Post

    Fuel Gauge Pegged...

    Well I added some resistors to the line going to the sending unit and finally got the gauge to come down a bit. The tank is full right now so I...
    Post by: jason74, Aug 20, 2007 in forum: Early CJ5 and CJ6 Tech
  10. jason74
    Post

    Fuel Gauge Pegged...

    Thanks for all the info. I'm going to double check the grounds today. If everything checks out then I'm going to go buy an adjustable resistor...
    Post by: jason74, Aug 19, 2007 in forum: Early CJ5 and CJ6 Tech
  11. jason74
    Post

    Fuel Gauge Pegged...

    Yeah I checked it. Seems to be fine.
    Post by: jason74, Aug 19, 2007 in forum: Early CJ5 and CJ6 Tech
  12. jason74
    Post

    Fuel Gauge Pegged...

    Ok, here's the deal. The PO installed a VW sending unit on the under seat tank. When I bought the Jeep it had an aftermarket fuel gauge on it....
    Post by: jason74, Aug 17, 2007 in forum: Early CJ5 and CJ6 Tech
  13. jason74
    Post

    Fuel Gauge Pegged...

    Post by: jason74, Aug 14, 2007 in forum: Early CJ5 and CJ6 Tech
New Posts