Sorry in advance to bump this for what is likely a dumb question. I’ve had my carb “rebuilt,” but it still idles poorly when fully warm. I don’t...
Nice. I’ll message you if I get it going well enough to brave Saddleback Mountain again.
I’m in Tustin.
You may have found my vacuum leak. There’s significant play on that shaft. I also had some gas leak out around there when playing with the...
I’m in S Cal also. Did you use a place around here, or send it out? Someone referred me to El Monte Carb. Those online places look like they do...
Exactly what I was looking for, thanks much.
Thanks for this info. It mirrors what’s in the Haynes manual. On your first page, figure 7, it shows the fast idle arm and adjustment screw, as...
I’d appreciate it if someone could take a look at their Carter YF and let me know if the idle screw contacts flat surface on the idle arm, or if...
Thanks - I hadn’t considered that. I’ll check for play. I assume someone sells a kit, or carb shop only? A newly refurbished YF is $300, so a...
Hello- This is likely the dumb question of the day, so thanks for any input in advance. 1966 CJ5A won’t idle once warm. It hunts and stumbles,...
Dumb question, I know, but did you guys bolt those cages to the frame or just the sheet metal?
Thanks Rick, Would you mind confirming that I have the same alternator in the Amazon link above? Is this the bracket you used? Delco Alternator...
Thanks Walt, Just so I'm clear - no pulley change? Is there a preferable clocking position? The Mad Electrical article would indicate this 63...
Sorry if it's bad form around here to bump this thread, but it has many similarities to my questions. 1966 CJ5A, F134, no AC, no radio, pretty...
Separate names with a comma.