I would look at the solnoid on the fender. the "S" termnal should have power in the crank postion. the other small tremnal I think it is labled...
taping on the dis.is a not a good option. make sure you have oil psi when you start the motor. some motores you would push the oil pump drive...
Manifold vacume and go to flaps (frendly local auto parts supply) and ask for vacume hose it is rubber you will probly need 1/4 hose.
It could be a lot of things like Dave sead. one thing pops in my mind to ck. is the float/nedle valve . is fuel comming out the vent.
I have allways been intrested in regruving the big lugs on the thornbirds. to see if that would make them any good. so far the best all around...
I have probly changed 700 to 1000 tires in my life. arround 75 to 100 of them by hand. if you know what you are doing it is not too hard if you...
I have had mine for years and it is a great welder for most jobs 0.030 wire is the one I use but for thin metal I have found 0.023 is a good wire...
:iagree: count the # of cells in the bat. 3cells=6v 6cells=12v
the hole is probly their to get the air out from behind the t stat so the engine wount over heat before the t-stat gets warm enough to open. some...
ck connections on the bat. and starter if good probly the solnoid.
ck u-joints are they all new? also make sure your drive line anges are with in opperating spec. for the u-joint or cv joint. may be axel rap is...
:iagree: ck the heater core.
I would be worried about co gasses from burnt fuel.
what we have done in the past on deisals is to pull the pan and pressurise the cooling system go under the motor and look for leaks. good luck...
dont forget to ck the mounting of the box and frame. suspension and alingment can make a big diffrance in how it steers.
Separate names with a comma.