Thank you guys for all the input. After reading all the post I do believe I will get a car hauler to tow the jeep with. Thank nk you once again...
Good Morning, I've never towed a 4wd, and I just want to make sure I tow it correctly. I have a question about towing on a truck dolly. Of...
Spacers made out of aluminum [IMG]
I also ordered a new t-case mount but decided to eliminate the "z" bracket. I did have to drill a hole in the crossmember in order for the mount...
Yeah, not sure of the rhyme or reason seven4eight, but just went with the 3/4 inch measurement. Then I lined up my back driveshaft and it looked...
So I was able to make some spacers out of aluminum. I have three on each side measuring 3/4 inch. [IMG] next step is to replace the "z"...
Thank you for the information duffer, I went back with all original shackles and springs so no lifts here that would mess with the driveshaft...
Ok so I kept the originals, actually the 1st picture is one of them. so should I put them back? And if so, should I have to loosen up any bolts...
Hello jeep people, I've been following a few threads on here about transfer cases and transmissions. I've noticed in some of the pictures that...
Ok thanks for the info, but I'm guessing it would work either way, just a matter of if you want to put new holes into the cross member.
Johns1967CJ5 so you used the new bushing with the "z" bracket?
Wonderful short thread Craig1953, very well illustrated with all the pictures. We love pictures. Glad you were able to get your mount replaced...
It sounds like, according to Wheelie, the new bushing should mount directly under the t-case eleminating the "z". I have the same setup and also...
Separate names with a comma.