Clint, I feel your pain!!!!! I just finished my frame a week ago. Fortunately I am doing a frame-off so getting around is easier, but I still...
Patchy, I buy most of my parts from Krage Motor Sports at http://www.jeepdoc.com/default.asp I bought drums from them and the price was...
Patchy, A note about your front axle. Most likely you have a Dana 27 front end. The drums and hubs are held together by swaging of the wheel...
I just finished my frame with Rust Bullet. It's tough, goes on thick, can be applied with a brush, and is really tough. It will not be affected...
There should be a small spring going around the lip of the oil seal. This spring should always go to the 'fluid' side of the shaft. I have never...
There is no piece of rubber. Was it part of a previous oil seal? Looks like you may have found your preload problem.
GK, In the last sentence to my previous reply I said "Some diffs use a crush sleeve to set the pinion shaft torque. In this case, the pinion...
GK, The site Rick gave you for the set-up is pretty good and the pipe wrench idea is exactly what I use. The Dana 44 uses shims to adjust...
Sparky, I went the other way. I told the rebuilder the block was from a 225 by mistake, it actually was a 231. He checked the bores and said...
I don't have a tube of RTV with me, but I think the directions warned against using it in direct contact with gas. Better read the label....
Of course not, you're just short for your waist line.
This was a term I never heard of before in relation to springs. I did a little Googling and it seems that Camber is another term for spring Arch....
Bill, It will be some time from now. I don't have a suitable stand for test running and I am still at the frame-off stage of the rebuild. In...
Bill, I could blame the engine rebuilder for not checking the casting numbers, but then, I should have checked it also. The guy never saw an...
Well Mike, I agree, McRuff probably hit the nail on the head. The one thing I didn't consider was the weight of the pistons affecting the...
Separate names with a comma.
