Me too, with the firewall harness unplugged, the main power supply ring terminal off at the solenoid, I have a ground issue on the hot(testing...
Sorry if I confused, I never said it was an external regulator; I disassembled the entire alternator and checked each component individually....
It's a Delco Remy alternator. One large post on the back from the rectifier, and a two wire plug on the side where the solid state regulator is...
It will drain the battery down in a couple days. I am going to return the kit, I believe the regulator is defective; I get the same readings from...
Hi everyone, this site has been a great help in the past so I'm wondering if anyone can give me some ideas. My battery drains down quickly, I...
Anyone know what gauge metal the noram panels are that quadratec sells? Specifically the rear outer panels and inner fenders. Thanks
Hi, can anyone recommend a good air cleaner assembly for a 258 w/ a 2bbl carter on it. The local auto parts store has some small ones that have...
I am replacing the U-joints on my rear drive shaft(75 CJ5) and whoever replaced them before didn't use greasable joints. Can anyone tell me how...
Dana 20 transfer cases get sloppy at the linkage. Take off your shifter boot and you will see the linkage moving and the shift rods staying still....
Hi all, I have a question about my drive train. Should I have any play in my rear output yoke on the transfer case? My jeep just started making...
Separate names with a comma.