Thank everyone you have helped tremendously. And my front bearing retainer fits the GM throughout bearing (I din't know you could just buy one...
thanks a lot guys, I guess I should have told you that I have already mated the tranny to the bell, had the retainer turned down (around the bolt...
I am in the process of putting a ford t18 into my 66 cj5 and I have a few questions 1. Does anyone have a part# for the ford clutch disk that I...
I was lining up the holes on my buick bell to the ford t-18 and found that I can make the top two holes work, drill and tap one for the bottom...
Hey guys just wondering what I'm going to have to do to make the input shaft on that ford tranny work with the Dauntless V6, also how hard is it...
Hi chilli, I'm new to this board too, so maybe I shouldn't be giving any advice. but I have been trying to get my jeep going for 2 years now, and...
Hi I'm new to the board and am so glad that I found it, any ways I have a lot of questions now that I finally found some people that might know...
Separate names with a comma.