tubes from ebay, parts store, dodge dealer wont work they are all junk the only one that will work correctly is BULLTEAR. here is how I know-...
its most likely best, if they are broken, and you had to use vice-grips to turn them, its time for a set of new hubs.. its a good investment,ya...
sounds good im rebuilding my 73 as well http://new.photos.yahoo.com/crackerjax27526
I'm just going to carry a spare jeep with me where ever I go :AMC:
Re: How hot do it get? dang...:roll: thats no good, well atleast you have one i took my heater core out and havent put it back in yet ... :cry:
2x on the hard drive magnets I have 6 of them ready to go into my jeep one in each pumpkin one in the transfercase one in the transmission and 2...
Re: How hot do it get? it very well might be your problem. run the radio with out the motor going and see if it still does it that should tell...
yea its the right foot to brain connection that will make the diffrence, its not the strongest axle in the world but for light duty trail it...
I dont see why not i have a dana 30 front and a dana 44 rear with 3.73s and I didnt have a problem. I have to stick with 33s though because of my...
how long are your shackles from hole to hole iv been trying to find out because i plan on doing the same thing thanks in advance josh
I have a 500 cfm edelbrock carb on my 304 mated to a edelbrock torker intake the PO had a 600-650 carter afb on it and it ran way way rich ......
on my 73 cj5 I noticed on the bottom rad outlet its not round it looks a little smashed I am thinking it is not a good thing. i was wondering...
i think the best primer is epoxy primer as for por-15 my frame will be seeing it soon as i am done takeing off all the rust with a die grinder...
true, it would be easyer to paint it all one color so you would not have to worry about tapeing and over spray
Separate names with a comma.