Yes- early Dana 44 with the tapered axles. The tag suggests a 5:38 ratio, which was common in 1962. the front is a model 27. It appears to have...
A rear swing away style spare mount does work well. There are styles that swing down which are light and simple. The side mounted spare was...
The later 9" brakes (sixtys CJ5 style) use a bendix action rather than the fixed pivot Lockeed action that the earlier (CJ2A style) 9" brakes...
They used to put those on the Model 18's. This was before the Warn overdrive was available. Probably not the best way to go. They refered to...
I would expect that brass stud to have been connected to the automatic transmission kickdown linkage.
Jason-- If popping out of second gear in your T90 is the only issue and a whole rebuild is not needed. That can be fixed with the trans in the...
[IMG] Here is a '63 CJ5-- It did not originally come with the AC ducts you see on the right of the glove box and above the steering column....
The original clutch cross tube setup has two levers welded to it. One of the levers connects to the clutch pedal via a rod. The other lever goes...
I have the Advanced Adapters chain clutch setup on my '63 CJ5 with a Ford 302. It is often used in very rough and twisting terrain and there has...
Failure will not occur with direct - straight pressure on the rod. It will only occur with twisting or binding. An off-set can cause this twist....
I have some concerns with the shaft coming from the bottom of the pedal eye rather than pushing from the center.
You might also contact Herm for discussion. I put one of these on my CJ5 a few years back. I found that I had to place a washer or two on the...
Zinc Di-Phosphate in engine oils is important for high pressure areas such as the flat lifters style cams used in most older engines. Newer...
The early model Jeep with the Model 18 transfer case (this has the driveshaft outputs offset from the transmission input). This allows using the...
A three wheeled Jeep?
Separate names with a comma.