your welcome.
yes. it is in the hole under the carb
did you get the bolt under the carb?
I once had an early 5 that had been converted to buick power by a po. I got it after it had been sitting for 10 years or so . when I first started...
Don't make it too easy to remove, that fit is tight for a reason. the transfer of power from axle shaft to axle flange is through that connection...
I almost forgot. all the 73 to april 77 f250 beds had the hole in the side for the rear tank. it was just plugged with a tin cap. If you ordered...
I believe The last ford pick up with an inside tank was built in april of 77. F 250 frames changed in april. before that the 250s had a 34 inch...
Ive taken apart alot of jeeps that have a long bolt through the middle of the pedal shaft,and some different sized washers on the ends. It was set...
so you have been running it for a few minutes at a time? have you ever warmed it up fully? starting an engine and shutting it off with out letting...
Most of the jeeps Ive worked on (with pto winches) have spacers to lower the bump stops to prevent damage.
How long has that engine been sitting? how long are you running it?
I had a willys pick up with a spring over once. it would shear the zerk off the t case end of the front shaft. i replaced that joint with the kind...
I have 5.38 axle gears. cant go much lower there.
I know! But see here we go, Why dont I throw a ramjet in there too! how about yj spring over? Rock ram steering, High pinion 60's etc. You know...
I just got off the phone with mister o brien. Very interesting. I guess it is going to come down to $. I would like to get his gear set and leave...
Separate names with a comma.
