I'm pretty sure the motor mounts are original as it shakes a little bit. Would taking off the radiator shroud and using a floor jack with a 2"x12"...
Thanks guys for your suggestions and advice on my spare tire question. I'm a firm believer when I say...ask Jeep people Jeep questions. Thanks again.
I have 31 x 10.5 x R15 tires. The spare is a 15" rim but more like 28 or 29" tall. The spare has to be replaced because of cracked sidewall....
1960 CJ5, no tire changing equipment came with the Jeep. Tires are 31" x 10.5 x R15. Would a bottle jack be fine to use on hard ground or...
Thanks for all the answers and advice to my gas question,
I forgot to ask the previous owner which grade gas he used. I've been putting in mid grade? Suggestions please. 1960 CJ5 Fhead stock.
Thank you for the link on decals. Would the following be correct to use 2wd driving? Leave the transfer case in 2wd and the fourth shifter in...
I have four floor shifters, 3 speed forward, next is the OD shifter. So the third shifter is the 2wd/4wd? Does the fourth shifter from the driver...
At this point I'm not sure, AZ sun gets to me when it's 114, but I'm sure your right. Just for grins when I get the Jeep back and driving on the...
Back in 1970 I had a MGA with knock off wheels, went around a tight corner near my home going about 30 mph heard what I thought was glass breaking...
Got back from the shop where the Jeep is. The drivers side rear axle shaft sheared off. As long as it's there I'll just have both of them done.
Separate names with a comma.