If there is no heated shop around, an unfinished basement can make a nice warm place to work on parts. If you have a wife that won't take kindly...
I have been known to use an oxy-fuel torch and apply lots of heat. However i suggest that you do it outside as it will indeed make a stinky/smokey...
It does have a cutting edge but it's not on right now because I don't have a sufficient layer of ice yet. I need the Ice to protect the gravel...
why not just get a chevy axle and narrow it since you're gonna need all the parts anyways and are a bit more common than waggy axles
hmmm... perhaps
this weekend I realized I had 400 yards of driveway and no plow. So after a quick assessment of my steel supply this is what I came up with. It...
Yeah, looks like some one attempted a lift of sorts there which appears to be a bit on the jankey side but the rest looks rather well done. I...
ok i'll look at that thanks
so that's not an engine that's supposed to be in there?
A buddy of mine left this in my yard a few months back. He mentioned today that he may want to sell it but he wanted more info on what it was and...
A lathe with large swing is probably the most efficient way to do it. like mentioned before some of the big shops might not like to take small...
sexy!
yeah, i'm pretty sure it's never gonna be on the road. However, i have entertained the notion of just what it would take in this state to make it...
Separate names with a comma.