1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

rear oil seal

Discussion in 'Early CJ5 and CJ6 Tech' started by ron1, Dec 8, 2008.

  1. ron1

    ron1 New Member

    anybody know the part number for rear axel oil seal dana 44 taperad axel 1964 cj5
     
    ron1, Dec 8, 2008
    #1
  2. Patrick

    Patrick Super Moderator Staff Member

    Need to know which seal you need first. There's two seals on each axle shaft.
    That is, unless you need a pinion seal...
     
    Patrick, Dec 8, 2008
    #2
  3. ron1

    ron1 New Member

    need seal for both axles beside bearing
     
    ron1, Dec 8, 2008
    #3
  4. nickmil

    nickmil In mothballs.

    On the inside or outside of the bearing? there is a seal between the bearing and flange that goes on after the tapered axle is installed but before the flange is installed. There is also one pressed into the housing on the inside of the bearing that is installed before the axle is installed.
     
    nickmil, Dec 8, 2008
    #4
  5. Patrick

    Patrick Super Moderator Staff Member

    Yep, this is what I was getting at...
     
    Patrick, Dec 8, 2008
    #5
  6. ron1

    ron1 New Member

    sorry its the one pressed in the axel before axel goes in
     
    ron1, Dec 9, 2008
    #6
  7. Homebrew2

    Homebrew2 Member

    Ok, I can't prove this (cuz I don't have anything apart right now to double check) but, I think that seal is:
    Napa 13710 (Id=1.375", OD=2.286", thk=0.025") $22
    Autozone 42763 $16

    Would appreciate if anyone can verify or dispute :beer:
     
    Homebrew2, Dec 9, 2008
    #7
  8. EricM

    EricM Active Member

    EricM, Dec 10, 2008
    #8
  9. Homebrew2

    Homebrew2 Member

    Yep, everybody's got em. I was thinking he needed one yesterday, locally. Can anyone confirm or provide the part number?
     
    Homebrew2, Dec 10, 2008
    #9