Wheel Bearing Washer

Can somebody splain me how you get the washer bent outward over the outer nut?:?

 

very carefully
you place the tip of a prying device just barely under the edge of the washer; you then gently push your prying device against the wheel hub while watching the lip bend; once it has bent a little, you can then reposition prying device for the final bend over.
NOTE: it is best to use your prying device against the locking hub bolt opening, or slightly off center of it; the reason is if you bite too much all at once, you can break out the thinner un-reinforced portion of the hub circle.
NOTE: the secret is do not try to bend too much all at once; stay out on the edge of the washer with your prying device.

DISCLAIMER: all of the above my method; not responsible if your break your wheel hub or pry device; wear eye protection

 

and of course, your bending the washer over and against on of the flat sides of the washer

 

Thanks, I'll give that a try.