Probably a silly clutch linkage question...

Can the clutch cable (from the bellcrank to the t/o fork) be replaced without removing the tranny? I would assume so, but I haven't looked at it close enough yet I'm thinking (hoping?) that it can be done maybe by pulling the floor cover and then the inspection cover on the top of the bellhousing for access? I've got to get a new one, along with a new bellcrank assemly, and I'm just wondering what I'll be getting into... Thanks!!

BTW, where do you guys recommend buying these replacement parts for a good price? I assume they will be OMIX-ADA parts and there are a ton of places that seem to carry OMIX, but any place special you guys know of? Thanks x2!!

 

I am assuming your talking about a 134/t-90 combo. I don't even think you have to remove the tranny inspection cover. IIRC, its all outside the tranny/bellhousing. I think it also has an adjustment built into it, and I think you can just back it off by unscrewing it. Theres a ball on the release fork end, and a clevis pin with a cotter pin on the other end. (Once again, IIRC.) I'm sure someone will chime in if I'm too far off.

 

you can do it, just have to make sure the fork doesn't drop
go here: http://community.webshots.com/user/jpflat2a
scroll down to clutch and linkage; then go to F4 linkage
you will be able to see how it all fits together