1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

metal or alum?

Discussion in 'Early Jeep Restoration and Research' started by trailcrawler, Dec 9, 2004.

  1. Dec 9, 2004
    trailcrawler

    trailcrawler Central Ohio Cj'er

    Columbus Ohio
    Joined:
    Dec 5, 2004
    Messages:
    86
    I have a 75 cj5 should I use sheet metal or aluminum for body work?
     
    trailcrawler, Dec 9, 2004
    #1
  2. Dec 9, 2004
    jd7

    jd7 Sponsor

    Nacogdoches,Texas
    Joined:
    Mar 30, 2004
    Messages:
    1,745
    metal if its a steel body
     
    jd7, Dec 9, 2004
    #2
  3. Dec 9, 2004
    timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    23,596
    Steel. Won't aluminum on steel corrode due to electrolysis?
     
    timgr, Dec 9, 2004
    #3
  4. Dec 9, 2004
    trailcrawler

    trailcrawler Central Ohio Cj'er

    Columbus Ohio
    Joined:
    Dec 5, 2004
    Messages:
    86
    I have access to .063 alum for cheap and didn't know if would work. The floor pan is rusted through on the drivers side. The previous owner had several layers of rotting carpet as a patch. Thanks for the tips. I'll move on with sheet metal. I will post some pictures eventually. thanks again.
     
    trailcrawler, Dec 9, 2004
    #4
  5. Dec 9, 2004
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Not only that, but I would think the 2 would expand and contract at different rates. It would probably pull the joints apart eventually since I don't think you could get a good weld between the 2?
     
    termin8ed, Dec 9, 2004
    #5
New Posts