1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Gas Pedal To Throttle Linkage Setup

Discussion in 'Jeep Truck and FC Tech' started by jeepstar, Dec 15, 2019.

  1. Mar 24, 2020
    findleyk

    findleyk New Member

    Joined:
    Jun 8, 2010
    Messages:
    21
    I have been able to find a source for the FC gas pedal. Mentioned earlier was that they are available from several vendors. Is the gas pedal and mount just a CJ5 part that is repurposed for the FC? Any vendor and part numbers?

    Thanks....
     
  2. Mar 24, 2020
    findleyk

    findleyk New Member

    Joined:
    Jun 8, 2010
    Messages:
    21
    Correction

    I have NOT been able to find a source for the FC gas pedal. Mentioned earlier was that they are available from several vendors. Is the gas pedal and mount just a CJ5 part that is repurposed for the FC? Any vendor and part numbers?

    Thanks....
     
  3. Mar 24, 2020
    jeepstar

    jeepstar Well-Known Member 2020 Sponsor

    Sheboygan
    Joined:
    Jun 28, 2006
    Messages:
    1,531
    no, it isnt an ECJ5 pedal. the original most closely resembles a willys pickup gas pedal, but even that needs to be trimmed down.
    AFAIK, there are no aftermarket vendors with new replacements. ive looked and looked, and settled on a cheapy one size fits all hot rod gas pedal.
    no part number either.
    there was a website once upon a time where FC'ers gathered. the forward forum. but its shut down, and all information lost to the ether.
    facebook has a FC group, but they arent much help from what little perusing ive done there. i asked the community for a gas pedal and got no response.

    if you find out different, let us know!
     
  4. Mar 24, 2020
    henry donaldson

    henry donaldson New Member

    florida
    Joined:
    Dec 23, 2019
    Messages:
    24
    On the Kaiser Willy site 646509 looks correct. I know the bracket that fastens to the floor is correct. And the pedal comes off it at an angle, not straight which is correct. On Walcks 640720 also looks like it would work. Same floor bracket and angled pedal. The rod that goes from the pedal thru the floor is not attached to the pedal, it just rides/rubs on the back of it.
     
  5. Apr 2, 2020
    jeepstar

    jeepstar Well-Known Member 2020 Sponsor

    Sheboygan
    Joined:
    Jun 28, 2006
    Messages:
    1,531
    I used 1/16" aircraft cable, with looped and crimped. Ends, vs wire. To me, I'd worry the wire would kink too much.
    Resized_20200402_084319.jpeg
     

Share This Page

New Posts