1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

DJ3A Rear Wheel Openings

Discussion in 'Flat Fender Tech' started by djcj3a, Jan 1, 2015.

  1. Jan 1, 2015
    djcj3a

    djcj3a Member

    Ukiah, CA
    Joined:
    Jan 12, 2010
    Messages:
    206
    By chance, does anyone know If the rear wheel openings on a DJ3a differ from a CJ3a in curvature?

    A few months back, I picked up a set of warrior products rear corners for my project, and went to install them today. They don't follow the wheel opening, and they're also taller than the body. Comparing pictures online, it seems like I have the correct set, being the ones for a CJ5 have an angled cut to clear the body lines, where mine do not.

    I can take some pics and measurements tomorrow. If they are correct for a CJ3a, I'll just modify them to fit, otherwise I'm going to have to try and explain to Quadratec what I'm dealing with, and hope they'll exchange them after all this time.

    Thanks
     
    djcj3a, Jan 1, 2015
    #1
  2. Jan 2, 2015
    garage gnome

    garage gnome ECJ5 welder

    Western MA
    Joined:
    Jun 19, 2009
    Messages:
    3,093
    They should be the same for a 3A and DJ.
     
    garage gnome, Jan 2, 2015
    #2
  3. Jan 4, 2015
    aallison

    aallison 74 cj6, 76 cj5. Has anyone seen my screwdriver?

    Green Cove...
    Joined:
    Nov 24, 2006
    Messages:
    1,929
    x2 and agree. We need picts.
     
    aallison, Jan 4, 2015
    #3
  4. Jan 4, 2015
    djcj3a

    djcj3a Member

    Ukiah, CA
    Joined:
    Jan 12, 2010
    Messages:
    206
    It's been too long to return them, so I ended up just trimming them to fit. I'll post some pics in my build thread later. Thanks for the help.
     
    djcj3a, Jan 4, 2015
    #4
New Posts