1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

`69 plow jeep. former trencher

Discussion in 'Builds and Fabricators Forum' started by termin8ed, Nov 9, 2013.

  1. Nov 9, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]
    [​IMG]
    [​IMG]

    Had no front brakes. Took it to work last week and bent up some new lines. I'll get more pics posted as work progresses
     
  2. Nov 9, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Got lucky and the master cyl was still good. The wheel cyl's where siezed up but managed to clean up one of them to reuse. Had to bend new s lines and replace the rubber lines and steel line to the right side. Bled the brown brake fluid out and now can see where the rear is leaking. Next summers project. Front brakes stop better than no brakes.
    Planning on changing plugs and oils monday then trailering it back home
     
  3. Nov 9, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    And does anyone know what vehicle to ask for when looking for a dully dana 70 rear axle brake parts? 1969 axle
     
  4. Nov 10, 2013
    wheelie

    wheelie beeg dummy 2024 Sponsor 2023 Sponsor

    York, PA
    Joined:
    Mar 6, 2004
    Messages:
    4,504
    Don't know if an FC 170 in dually form would work. Maybe an period small dump truck like and F350 or C30 or something. Just guessing.
     
  5. Nov 12, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Think a ford 350 is my best bet. Just need to take stuff apart and I decided today that, that is a job better suited to the spring when I have more time and money...

    ...drove around a little at work and need to try beeding out some more air I think. Compression was 120 on all 4. The back 2 cylinders looked pretty wet (oil) when I had the plugs out so hoping its just the valve seals. It smokes pretty bad
     
  6. Nov 12, 2013
    Diggerjeep

    Diggerjeep Member

    Joined:
    Oct 19, 2010
    Messages:
    196
    I have a 68 with dually rear. I pulled the wheel cylinders and matched the numbers at a NAPA store, but that was 8 years ago, so don't remember the numbers. Yours being an 69, it should have a dual reservoir master cylinder correct?
     
  7. Nov 12, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    Yes. Dual mc. We tried looking up stuff at carquest the other day and pretty much decided parts are available, just have to pull them to match.
    Just a lot more work and time involved right now. I don't want it to drag out since I need this jeep to plow.

    I did drain and refill both diffs yesterday. There went one whole gallon of 90 weight. Engine oil tomorrow and trans. Hope to bleed brakes a little more too. Had to pick up my daughter from school early today
     
  8. Nov 14, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]
    [​IMG]
    Here's 2 of the pto that was on it. Looks like some kind of bronze or brass sleeve that bolts around the pto for the pivot points. The pto would drive a hydrolic pump in back and the hydrolics would then have a second shaft driving that gear attached. It was moved over by levers on outside of drivers door. The gear moves over and engages a ring gear welded to the parking brake drum. Transfercase would be in neutral and hydrolics would move the jeep along by the parking brake drum.
    Took this off to givee back to my uncle. I got the jeep. He gets to sell this8)
     
  9. Nov 14, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    [​IMG]
    [​IMG]
    Here's the jeep without the dually tires and flares. Had to take them off to get it on the trailer. Ill be putting them back on soon now that its home
     
  10. Nov 14, 2013
    wheelie

    wheelie beeg dummy 2024 Sponsor 2023 Sponsor

    York, PA
    Joined:
    Mar 6, 2004
    Messages:
    4,504
    Dig the half cab.
     
  11. Nov 14, 2013
    68BuickV6

    68BuickV6 Well-Known Member

    Hesperia, CA.
    Joined:
    Mar 12, 2012
    Messages:
    2,161
    Dig the dually. I bet its pretty stable.
     
  12. Nov 15, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    I would think it is. The 11 leaf spring pack is pretty solid though:D. Haven't played around with it too much off road yet.
     
New Posts