I think the fitting that Parts Dude 4x4 has will be a close match to the original. Brake line tee with Brake light switch port - Partsdude4x4
Another suggestion: A failed or failing water pump can cause the problems you are describing including the new noise you are hearing. You can...
I agree with what Tralehead said. My father always told me when you buy quality tools you will only cry once. Also, Harbor Freight's wire...
FYI: The charge/indicator light must use an incandescent bulb; an LED bulb does not create enough load to trigger the alternator to charge. The...
My Dauntless CJ5 had the same issue when I bought it. The previous owner had recently replaced the exhaust system and it had several leaks in...
Thanks Glenn, good to know. Martin
Jw60: Mine is very close to that noise level. duffer: After I first got "Old Yella" home I drained oil from the engine, transmission and...
I have a 1970 CJ5 with the Dauntless V6, T14 transmission, and Dana 18 transfer case. My question is how much transmission/transfer case noise is...
I don't want to be a "know-it-all" but you may want to turn your louvers around 180 degrees so the air under the hood can vent out while driving....
Two months ago, on a rainy Sunday night, I had a new battery short out while driving "Old Yella", my 1970 CJ5/Dauntless V6 :censored:. The ground...
The leaks on my ECJ5 were free too, the seller didn't charge extra for them.:rofl:
I've got a solid tailgate from a '62, surface rust but no rot. PM me, I'm in Pensacola.
Body looks in good shape. well worth $700. Willys Jeep Military Body Tub - auto parts - by owner - vehicle... (craigslist.org) Also '65 CJ5 tub...
I have found the easiest way to cut and shape foam is with an electric knife. I prefer to stack thinner layers of foam using rubber cement. I...
I agree. First gear in low range with o/d is the "Goldilocks" speed when I'm moseying around my property checking firebreaks, feeders, etc. - not...
I personally believe an overdrive is worth it. I have a Dauntless with 4.88s and installed a Saturn unit about a year ago and have put about...
That's how I did it when I replaced the in seals on my front axle. I used a ratchet strap to pull the carrier. BTW getting the inner seals out...
Thanks Donny, your response is the information I'm looking for, I did not know the 225 intake was split to feed each bank separately. That does...
Yes, the 32/36 is a progressive 2bbl. I am looking for better fuel mileage as I drive my CJ5 almost daily and at <12-13 mpg it does get $$$....
Has anyone installed a Weber 32/36 carburetor on a Dauntless 225? If so what adapter(s) is needed? I have a new 32/26 carburetor setting in the...
Separate names with a comma.