I got some Permatex 2 but it seams too thick to stay underneath a pressed in seal. Can it be thinned to a more liquid state?
I stopped by a transmission repair shop and asked them about removing/installing the seals. They said that they always use "green Loctite" on...
Success! I finally got the seal out - small chisel, seversl sizes of screw drivers, pry bar, heat & brut force. A few nicks & scratches in the...
Thanks for the suggestions above, I will try again tomorrow & try to keep damage to a minimum.
I tried the tricks from the forum (self drill sheel metal screw & screw driver to pry out) but no luck. I then tried a slide hammer, but it just...
Do the SM420 and Dana 18 share oil through the adapter?
Separate names with a comma.