i would highly recommend using grade 8 bolts for that. we use trailers around the farm with that kind of axle leaf spring clamp and anything other...
i used a '77-79 iron duke distributor in my cj5 w/ a chevy 153 engine. those years were factory 4cyl hei. 1978 PONTIAC PHOENIX 2.5L 151cid L4...
Id be wary of those Mr. Gasket fuel pressure regulators if i were you. every one ive had has failed spectacularly in a fountain of fuel all over...
You can do it with the body on if dont want/have to modify the front cross member. ive seen people fab brackets where the steering box hangs on...
i will when i get it installed. heres a link to the wheel on speedways website https://www.speedwaymotors.com/15-3-Spoke-Outlaw-Wheel,7262.html
i found that speedway makes an outlaw 3 spoke with .5" dish, so i went with that and a grant column adapter. but thanks for the imput
I want to put a smaller steering wheel in my 1970 cj5. it has the original 17" bus wheel and with my 24:1 saginaw box i cant whip that large wheel...
hi all. so im working on my 68 cj5 and i swapped in a dana 30 front from a 74 cj5. now because of the engine swap i did the front driveshaft the...
omc didnt make a reverse rotation 120 so i should be fine
i am in the process of a chev 153 swap. originally an OMC 120, its been rebuilt with flat top pistons and a clifford intake. its mated to a...
you can buy heim joint boots and cover the joint with heavy grease before putting the boot on. we do this on some of our brush shredders around...
i would LOVE detailed drawings and measurements of that 4WD/AWD conversion for the Dana 18 so i can put it into solidworks 3d.
I did this conversion on my cj5. i used a dual swing pedal kit from advance adapters and it uses a chevy clutch brake MC combo that was used on...
I have a Hobart 140 mig running .030 flux core. i love that welder. easily my most used welder, and i have 220v, 3 phase, and 480v welders. its...
we use mechanical gauges in our self powered spray rigs on the farm. i don't like the copper lines because they will eventually vibrate and crack....
So ill post my Saginaw steering. im going for a more basic restomod. no big power, no massive tires, not super heavy weight, and the chevy 153 im...
The t14 has a t case already mated to it, so output spline count shouldn't be an issue. whats the easiest way of checking the intermediate shaft...
Im running 5.38. the only reason i even considered it is because i already have the t14 trans and t case and crossmember. it would also put my...
Ok so im new to the forum but have read many posts on the website for years before making an account. so a little background info, and if this...
Separate names with a comma.