Oh and by the way don't make the same mistake that I made by not double checking your part numbers. I ordered the 4045 and 4046 calipers. I...
Now I am a little confused. Do the bearings and races in the D27 have to be replaced for the conversion to work, or is this just if you have...
I got the pertronix flame thrower coil on and the ignitor dialed in tonight. I started it up and it sounds like she is running much better. Even...
Wow, $130 for king pin bearings, cups, and seals. This is getting ugly.
One of the things I am beginning to figure out is that I think I like working and learning, as much as I like finishing my project. In the last...
Yeah I shelled out an extra $115 when I went back to exchange the rotors for Wagners and the pads for organic type.
Tonight I installed the pertronix flame thrower coil, electronic ignitor, and got the knuckles apart. Word to the wise for you all doing the disc...
I looked into doing the dana 30 swap as a much cheaper way to accomplish the disc brake conversion. What I ran into is I could not find one with...
Thanks for the info it was really helpful. I know they say hind sight is 20/20, but looking back I really wished I had ordered the disc brake...
I don't mean to hi-jack your thread, but I am working on the same project. Since I am waiting on parts and have a leaking knuckle. I decided to...
Yep I am on my way to take them back right now. I hope the wagners work.
What method did you use to remove the old studs from the hub? Also how did you go about pressing them into the rotor and mating the rotor and hub...
I got everything torn down to the spindle tonight. I am headed to buy all the parts tomorrow. Is there anything you ran into that I haven't read...
I did check the compression. I just ordered the pertronix ignitor, flame thrower coil, and everything I need to be able to do a disc brake...
Thats great. I haven't got my problem competely solved yet. It is running much better and I don't notice the stumbling as much since I took the...
Would that cause back firing and a rough running engine. I must say that in all the websites that I have been involved with, this one has had the...
When I changed to the new mufflers I changed the gaskets. I also checked for header leaks and tightened all of the header bolts. I still believe...
Sorry for my stupidity but I am not really sure. Like I said I am used to rigs with Fuel injection or propane.
Do what?
I have it advanced to about 7-8 degrees. I went and picked it up from my buddies shop tonight. It is running better than it ever has. I still...
Separate names with a comma.