Did my 68 cj5 come with factory seatbelts.
i wanna run a can of seafoam through the vacuum, can i use the line that unplugs from the distributor. cheers
I wanna start gathering parts can somebody throw up a parts list of what I need, what cars to look for at the junk yard, etc. I have a 68 cj5 v6...
What are my options for replacing my headers on the old girl, the old ones are in rough shape. Trying to keep cost down too. Cheers
its backfiring from the carb so i took off the distributor cap and noticed i'am missing one of the small springs on the arms, is this why its back...
i can move it by hand, is there a way to tighten it if i take the cap off, or is this how it is on this old engine.
so i have been fixing up a 68 cj5, it came with a new fuel tank which goes under the drivers seat, and a new 6 hole sending unit, somebody before...
68cj5 v6 dauntless, I snapped off the end that goes into the brake cylinder, rusted pretty good, its a steel line that screws into the wheel...
Gonna do my first oil change on her, I live up in central Canada, and will be only driving In the warmer monthes, what weight of oil do I use and...
replaced all my tie rods and tubes for my 68 cj5, how tight do i want to have all the nuts on everything, do i want it tight enough so i can get...
Theres a cap with 4 bolts on top and on the bottom, 2 bolts from the top cap hold the brake line in place, are these knuckles filled with oil, one...
Replacing them but cant seem to get a wrench or a socket on them do I have to take off my hub the one with the huge nut, and would I need a puller...
got this jeep as a project and have been fixing it up, it has the v6 dauntless with the gas tank under the driver seat, it came with a new tank...
So I got my tie rod kit today, tie rod, tubes, etc, and it seem the clamps are a bit to small for the tube, did they send me the wrong size.
My 68 cj5 rear lower spring plate where the shock bolts onto broke, the nut that is,so I have a new one and they dont come with a nut does anyone...
What should I do, I have a 2.5 lift iam putting on and these are the shackles that are on right now. Do I use these ones or replace with...
Putting on a 2.5" lift, well I was taking off the bottom side of the leaf spring plate where the shock bolts onto and snapped the bolt off, both...
my 68 cj5 won't turn over, my gauges light up, the pos cable that goes to the starter has no volts when the wife tries to turn it over and i have...
how do i get the nut off the bell crank, the big bolt that runs through it all, i have all the other bolts loose but that big one i can't budge,...
Will these work on my 68 cj5 v6 dauntless, 1949-71 4 CYLINDER CJ, TIE ROD ASSY W/ TUBE, LEFT SIDE, and right side 19.75”...
Separate names with a comma.