Short answer. No. You have to disassemble the entire transfer case.
I just rebuilt my Dana 20. Even with working pills the rails will allow 2 Low. It is the shifter mechanism that prevents two low. The sloppy...
If you’re planning on on using the RPM manifold I’d definitely go with the 268 cam. But I’d definitely also make sure I have good valve springs....
What are your plans for your Jeep. If low RPM rock crawling is in your future I’d probably stick with the Edelbrock Performer. If mud or sand is...
First off I’d like to thank Nickmil whose original post made my successful build possible. The purpose of this post is to clarify and inform...
Subscribed thanks for the information. :clap:
I used 1/2” plate and 3/8” plate.
Yes there is a cross brace available for the intermediate Jeeps....
1981? Looks like you got your money’s worth. But yes, I’ve broken two cheap vices in the past couple of years, finally bought a used Wilton.
Here is a picture of the mount I made it if 1/2” and 3/8” have late steel.
Here is a picture of my stock bracket with a field repair.
Please tell me more about your trailer. I currently flat yow my 72 CJ5 but the idea of an enclosed trailer is very appealing. Especially if it is...
I’m sorry. Worked all day. Just pulled the part to compare to picture you sent.
You’re absolutely correct. I’ll DM you.
hi Oldpappy the three bolt one will work fine, that’s the one that was in there. $50.00 is more than fair, do you take Venmo? Thanks again.
Unfortunately, that looks completely different than the stock mount. But thanks for the reply.
I have a 72 CJ5 with power steering that was added by the previous owner. They reused the factory cast steel bracket that used three rather than...
That’s a good lookin Jeep.
Lookin good
Before you try to start it pull the air cleaner and pump the throttle three or four times to verify no fuel. If no fuel, check your float level...
Separate names with a comma.