Pic below. It closes the gap between the top and the indentation for the gas filler neck. Not required, but would make things tighter. [IMG]
Coil?
I don't know about the DJ's, but if it was a CJ a 69 body would fit on a 61 frame with no modifications. I don't think you'd even be able to tell...
For the t-case, I was able to squeeze the quart bottle enough to squirt it up into the hole. You just have to refill the bottle a few times b/c...
Well, the TJ seat in the ad is about 40", so no go there.
Don't know, personally, but I emailed one of the guys in the ads asking to measure it, so I'll know for sure.
Ha, you nailed it. Should've checked there, but I wasn't sure what would fit. Thanks!
That's just seat covers, isn't it? I'm talking about a whole seat (frame, mounts, etc.).
Anybody use this utility seat for a rear seat? http://www.northerntool.com/shop/tools/product_32194_32194 Based on the dimensions, it looks...
There are different kinds of guages/sending units. Ones that read full with no power and ones that read zero with no power. If you mismatch the...
Does the switch otherwise function normally? If so, I would agree. Mine was blowing fuses, but the switch was going bad b/c you had to wiggle it...
Where did you order from? I just ordered and installed one from Morris 4x4 Center that works great. Seems to be well-made, but we'll see how it...
So, knowing that this is years of cobbled together mess, where were the actual bolts and rubber mounts from the factory?
Oh, man, well, here's what I've discovered. The aforementioned piece of wood (just behind the right-front wheel, directly below the cowl):...
This is like 5/4 decking or something pretty thick. So, I guess the answer is 'no'?
Do these jeeps have shims under the tubs? I found a hunk of treated wood between the underside of my tub and the frame. I assume this was...
'70-'71 should be the same dimensions as your '60 (or close enough that it shouldn't matter).
That's what I was thinking, too. Fix the PO's mistakes and you've got upgraded steering on the cheap (possibly).
Thanks for all the input, guys. I think I'm going to just rebuild the D18 and T86 both. Herm's prices seem decent and I think I found a decent...
I don't understand why people say the T90 is stronger than the T86. Other than all the gears being helically cut and the splines on the "slider"...
Separate names with a comma.