Finally after a kitchen project delay..... I]have progress again on my jeep project. Manual steering box install from 79 jeep.... Thanks to mcruff...
[IMG][/IMG] [IMG][/IMG]e [IMG][/IMG] Finally have something to post again. Rebuilt carburetor, Put body on frame. Have some great looking...
I had many engines done in kalamazoo michigan. The napa on centre street does a fantastic job. I believe the gentlemans name is tom. Cleanest shop...
[IMG][/IMG] Did a lot this weekend . Rear drive line in. Just need the front propeller shaft and the drive line will be complete....
Made alot of progress this weekend. Transmission in and boxed in the frame for saginaw steering.\[IMG][/IMG][/IMG] [IMG][/IMG] [IMG][/IMG]...
Well I checked it with the old one..... It looked the same diameter.....Did not slip it over the shaft.....Now you have me wondering
Why is it you never get as much done as you plan on the weekend. Oh well It's starting to look like an engine. [IMG][/IMG] [IMG][/IMG] I have a...
I used the grease and the dowel and was able to pop the pilot bearing out and placed the new one. After that the clutch and pressure plate went on...
[IMG][/IMG] Well starting to put drive line together. It looks a lot better then it did. Have a question. How important is it to change the pilot...
Finished painting the engine except for the timing cover. Also have rebuilt transfer case and mated it to the t-86. [IMG][/IMG] [IMG][/IMG]...
Getting closer.....engine almost together[IMG][/URL][/IMG][IMG][/URL][/IMG Sealed power rings were great. The hasting rings must have been...
Ordered some sealed powered rings. They will be in Monday. I'll pick them up Friday on my day off. And I'll try again. I returned the other rings...
They are hasting rings. I did put the compression ring in the cylinder and there is a gap. The oil ring will not go in the cylinder. I have taken...
Rebuilding the buick 225, the Dauntless. I tried fitting the rings I purchased at auto value. The top two rings fit okay but the oil ring were to...
thanks I will do that
[IMG][/IMG][/IMG][IMG][/IMG][IMG] Engine is appart need to clean up everything and mesure. It looks prett good so far. I think I will be able to...
225, but i cried for help to early. went back out and used a wheel puller by screwing in threaded rod into oil pan holes and then tapped on the h...
Help? Torn engine apart cannot get last last main bearing out, Manual says I need a special tool. Need to get crank out to measure it.
Okay, After talking to some friends I've decided to go through the engine. I was suprised how inexpensive the rebuild gasket kit, rings, bearings,...
Separate names with a comma.