That's all I use...Rotella 15-40, works great in my motorcycle as well.
For the ends I used a brass fitting and double flared the steel line. The brass should seal it tight. On the other end at the pump I just flared...
I just bought the entire left and right assembly from Walcks. It makes it easier to align by measuring and comparing to the old one.
Just like my 68, from left to right Transmission, overdrive and transfer case. If you want to confuse people, add a 2 speed pto and change the...
The original old plug wires can not handle the high voltage coil. You have to get some quality spark plug wires. When I upgraded to the...
Now I am Curious I have a 68 with the v6 and I have never seen a cable that would hold the engine, where would it be?
I remember from working with a master welder that cast iron can be welded by first preheating it (red hot) and using a special welding rod. I...
Does it go away after the engine warmed up, then it might be a stuck lifter. If it does not and it is a rod then you risk breaking the rod and...
In some states it could turn your '66 into a '70's model, since the VIN is on the frame. Check with your DMV.
I worry when mine stops leaking. :D I have tried just about anything and Tim is right they all leak from somewhere. Even if you seal all the...
I would start with the distributor, check for water/moisture in it and the plug wires, don't forget the plug wire from the coil to the...
I stuck to the stock carb (2G). I have one on the engine and a rebuilt one on the shelf. They are easy to rebuilt and adjust.
Welcome, where in AZ. Is the steering worn or just loose? I tightened mine. Try it first, if that won't work it is worn. Look at the steering...
Yes, go under the jeep and measure the shaft. On mine (1 1/4) the shaft sticks out a bit on the rear.
Look here for the float adjustment http://www.autozone.com/az/cds/en_us/0900823d/80/1d/73/d7/0900823d801d73d7/repairInfoPages.htm
As for the idle mixture screws, they are in the front under the bowl. Both screws are idle mixture. There is one screw on the linkage that...
If the new pump has a higher pressure,then you are flooding the engine (happend to me, I had to adjust the float). As for adjusting the carb,...
Possibly residual oil left in the pipe.
Once I got the nut off my steering wheel, I tried a puller to no avail. I used a 24" crescent wrench, adjusted it to the steering tube, moved it...
If it has a dana 18 then it it is 2wd high 4wd high Neutral 4wd low
Separate names with a comma.