Anyone have experience with the CRT distributor for sale on e-bay? I am currently running prestolite with a blown out advance on 71 w/ 225....
I had a similar problem with a new master cylinder. Ended up that the plunger was not returning all the way to release pressure. If I bled off...
Give this a shot. http://www.jeepdoc.com/catalog/zproducts.asp?id=314 If you don't see what you need, give him a call. Has done a great job...
Thank you and you are correct.
Well, I broke it. Not sure how, but the deed has been done. There were two teeth in the transfer case pan and they appear to be off the...
My Dad thinks I should paint the wheels yellow.
This was my first big adventure with the CJ. I have been looking up other State and National park trails in the Manistee National forest area....
The gearbox, steering column, pitman arm and adjustment sleeve attached to the tie rod end on the pitman arm are from a 1978 J-20 pickup. I...
:v6::AMC: Sorry, just playing.
Alright, alright, here are some pictures. I am a bit technologically challenged, so here goes. Here is my first attempt at dowloading photos....
Went to Silver Lake sand dunes last weekend. What a hoot!!
Well, it is finished. It took a little getting used to the touchier steering, but a whole lot easier to drive. Thanks for the help everyone!!!
An adjustment sleeve from a 1997 Cherokee, 2.5 ltr, fits perfectly between the stock tie rod ends!!!
I am down to the tie rod set-up. The J-20 pitman arm tie rod end hole, on the Saginaw power steering box, is considerably larger than stock. Do I...
I finally found a little "round to it" and am back at the project. The pump bracket from the J-20 definately does not work. Is there a...
OK, 78 or older, is that the 3.2ltr?
OOOPs, I mean 1978 or newer
Anyone have one laying around they want to get rid of? If not, I need to look for a Buick of 1978 vintage or older with a 231 then? Thanks for...
That should be fairly easy if the bolts come out easy. Worst case is the bolts break or need to be cut. I bought a chunk of body mount rubber...
The exhaust is currently stock. By looking at the pictures, that is the wrong way for clearance?
Separate names with a comma.