the 3B pages are getting updated all the time if you look at all the engine serial # recorded in their database ( link below) only A, B and E...
•C: 0.002" undersized piston pin •D: 0.010" undersized main bearing journals from 3B page http://www.film.queensu.ca/cj3b/Hurricane.html
i asked similar question on 3B page after viewing a number of cj3b photos with extra set of rear hood catches, was told in the day it was a...
i have same distributor in my '57 3B - i picked up cap/rotor/points from willys overland as they list this specific distrib - have not installed...
went thru a knee high stack and found it , got a little distracted during the bree issues but eventually opened the jan 2002 issue - i think...
I remember the article with pic of the custom adapter - give me a few days and if I find will post a scan ... Randy
7 years ago I put a '91 4L H.O. (casting #7120) head on my 89 258, and a mopar efi kit, 4L headers and catback, was able todo all the labour -...
there are at least two crank nut sizes for F4 my '57 3B had a 1 3/8 nut , the overhaul on 3B page had a 1 7/16 nut check out the 3B page for...
classic enterprises http://www.classicent.com -or- jeep panels in Maine...
I recently cleaned mine with engine degreaser, it made it fairly easy to clean the tar dirt that collects in the outter compartment where the air...
dauntless46 , the 16 inch rim was std on 3B with 15 inch optional , the willys truck used a slightly wider 15 inch rim with same looking center...
16x4.5 - bolt pattern 5x5.5 (ford) , tire size 6:00 x 16 they would usually be stamped Kelsey-Hayes in the inner tube groove repro's are about...
hi, are the CJ5 ventilated windshield rubber seals still available ? - the one along the edge of the frame section that pushes out, I have a '57...
Separate names with a comma.