http://www.mr-gasket.com/ProductDetails.aspx?modelNumber=1937&productID=39&majID=230&minID=2301&selection=7&minselection=0 Double check this, but...
You can invert the brake drum and screw the lugnuts in a few threads and use that to help pull the shafts out.
Unless he has lights on his floor, it's the caliper that's upside down and not the picture.
Some reading that may help. http://www.earlycj5.com/forums/showthread.php?t=59029&highlight=flat+connector...
Perhaps the different brake switches also were used depending on which pedals you have, ie, cable clutch was pressure switch on the master...
On a '72 the brake switch is located on the underside of the master cylinder and is a fluid pressure switch.
It means Hope This Helps.
It's all completely different and not useable.
The 'I' terminal is a full voltage feed for your ignition coil when you are cranking the vehicle. Ignitions with points used to use it to give...
That looks like the stock bumper to me.
You can buy seats for a '76 up CJ and will only need to drill two new holes in the seat base to make it fit. The passenger side brackets take a...
Here's another source for some beefy spring plates. You will need to weld on shock mounts though....
So the column is held to the upper mount by just a tight fit in the mount?
I wasn't sure if the clamp from the underside that secures the mount to the pedal assembly would work or not. I dimly recall where other people...
How did you do the mounts? Could we get some pictures of how you adapted the mounts?
The top straps for the box will mount to the tub, but the bottom mount will end up about 1" from being able to mount solidly to the tub. Make a...
Separate names with a comma.