Thanks for your suggestions. I'll try the J-B weld.
I found a hairline crack around the bolt hole in the bottom corner of my '69 cj-5 tranny where it bolts to the transfer case. Does anyone know...
Thanks guys. I've read a lot on this blog and will put the oil pan under until I make time to locate the leaks and seal. Until then it's Sta-Lube...
My 1970 CJ-5 leaks the 85-90 wt oil and overfills my transfer case and leaves a nice puddle on the floor. Since I only drive it in the summer...
Thanks!
Question, I'm going to change the oil and filter and if I drop the oil pan do I have to re-prime the oil pump? I don't think so but want to make...
I don't know for sure. I had mine apart and packed it as suggested and could'nt see it pumping with the covers off. I ran it some more and sure...
Thanks Jon, sounds like the easiest way to tell if she's primed. I will let u know.
yes...pump was off. Ran it for 20-30 seconds with valve covers off.
Has any one primed their oil pump with vasaline ? I have a 70 Dauntless 225ci and ran the motor at idle for about 20 seconds with the valve...
Thanks for the info. Rock auto doesn't list it for a 1970 though, only a 1968 & '67. I got another reply that gave me a delco # 1110322 p/n....
OK whats the model # for my 1970.
What type and model # distributor do you guys have? I have a prescolite and Pertronix doesn't make a kit for it. I heard I need a delco unit...
The chain must have slop in it because when I do rotate the crank the dist. rotor doesn't move for a while. 10* OR MORE. I'm going to change it...
I've had the jeep for 30 years and haven't driven it much. I decided to get a rebuilt because the vacuum adv. was shot. It started easy and ran...
I never had it apart but I did have the prestolite distributor rebuilt and replaced it back without turning over the motor. It ran lousy and...
I have a 70 Cj-5 with the dauntless V6. Besides taking the water pump off and timing cover, how can I tell if it jumped a tooth. I know I can...
I opened the point gap and finally got it to start for a few seconds. Pulled all the plugs and they are all covered with sooth. Could the...
Ok, making progress. Opened the point gap to .018 and the dwell is around 28* and it'll run as long as I increase the idle when she's stumbling...
Thanks for the advice everyone. The link is very useful...am going to check the point gap and open it up a little. Plus look into the other...
Separate names with a comma.