Yes, it is/was safety glass... it just spider webbed, but you can see the indents where the rocks pooched it out.. The entire both sides are...
Early this week I flopped my 47 2A, with 35s in the air. It landed upside down in a dry creek bed, and the windshield and my head landed too...
My 2-A springs are 1 3/4 wide, front 36 inches, rears 43 1/2 Compare that to what your CJ5 needs, I'm quite sure it isn't very close. Ken
I just moved from MT Baja Belted 33 x 12.5 x 15 on 8" chromes with 4 1/2 backspace to ProComp XTerrains 35 x 12.5 x 15 and put them on 8" with 3"...
Karl, Where / what / cap did you find to fit the underseat tank that doesn't leak? Part number / mfg / flaps? Another thread here started by...
Originally I had my 2 1/2 gallon air tank on a rear fender well. When I added a cross bar to my cage to provide support for 5 point harnesses I...
I found A.J., a super guy to do business with. http://www.taillightking.com/ He had some very small bulbs that fit into the original beehive...
These billet knobs with the shift pattern are very nice. They make both T-18 patterns, as well as T-98 and T/C knobs....
Please send a PM with details, condition, price, location etc. Or email at: ken(at)pantheus(dot)com I did order the 35x12.5x15, ProComp...
I've already been in touch with alcan. They want $ 190.00 a corner, plus moving and changing hangers, shackles & u-bolts to match wrangler specs....
I need new rear springs for my 47 CJ-2A, 1 3/4 wide, and since I have flat, old Rancho 2 1/2 lift, and am going from 33 to 35 (actually 34.7)...
I put 2 inch high end billet spacers on mine. I got less than 100 yards after locking in the front before I broke a u-joint on the outer axle....
These are being sold: http://www.extremeoutback.com/index.cgi?cart_id=5705566.3360&pid=67 I'd find easier ways to spend $ 80.00 but it...
I recently added the -125 MicoLock, with very satisfying results. http://store.zips.com/proddetail.asp?partnum=02-640-125 Well,...
I've used the Rancho 2 1/2 lift for years on my 2A. Soft, flexy. Will replace with the same. Ken
X2 I agree ... I added that rear fill gizmo to my 2A to feed the between the A frame custom-built tank I have installed. Ken
Here's the instruction manual, with troubleshooting at the back of it. http://www.thermadyne.com/firepower/literature/pdf/sales/56-1842.pdf HTH...
In addition to the material another factor that determines the amount of barrier gas needed is the "wind factor". If I'm welding in the shop...
I've no personal experience with this one, but was curious so did google of " Astro Powermig 110 " and found tons of info. hint hint
I was communicating with Harold, via email, until he found that my rig was so highly modified, and had no hope ever of restoration. Silence...
Separate names with a comma.