This looks like a good regulator for my Jeep. Economical too. I have an inline fuel filter screwed right into the carb so I will leave that one...
The plugs are fouled on all 6 plugs. The float is set to 19/32 inch. Maybe I should try a 46 jet size. Or maybe a fuel pressure...
Thanks Nathan, I did get the new valve cover and it is the small one so it is fine now. I replaced the power valve and cap , checked for leaks...
You just have to bend the wires somewhat flat in the same direction as the clip and feed it down thru. It's not hard to do and you will see when...
And don't forget to unscrew the emergency flasher button from the side before you start prying up on the turn signal switch. It is easily...
That metal plate is called the "lock plate". You need a lock plate compressor to push it downward slightly where then you can pry the metal...
I sprayed carb cleaner around the base and found a leak. So I pulled the carb off and looked closer and found a crack in the cap. You can see...
Thanks for the quick reply. My power valve has an internal vacuum as opposed to a port attached to it. I read somewhere that to test the power...
I checked the venturi size and it reads 1.08. Then I pulled the top off the carb and checked the jet size . It reads 47F. I don't know what the F...
yes it has been completely rebuilt ( by others) so I suspect the float is too high. I will try that first before I go searching for jets.
Hi, I ordered a Motorcraft 2150 rebuilt carb from e-bay to replace the crappy *** Carter I had on my CJ7 and it runs rich now , the plugs are...
When you were slowing down going up the ramp, were you still in gear? If so , maybe it is a bad U-joint. You really feel it when you start to...
Separate names with a comma.