I have someone interested in purchasing a T-18 from me and installing it into a 1981 CJ-7 that currently has an SR-4 transmission. We need to know...
I am in the middle of rebuilding a T-84. It is an early 1942 ford gpw model with the fill/drain on the right side. I have found that it needs 2nd...
I have a friend who says he has a 258 in his 1987 wrangler. So, am I correct in assuming that the '87 YJ had the same version of 258 that the cj's...
I found my old pair! For all who often ask, this is what they are supposed to look like. (yes, I listed these in the classifieds)
My 1972 steering column shaft has about a 1/2 inch of travel up and down through the column. I installed an aftermarket steering WHEEL, and the...
Opportunity to buy a 48 cj-2a, No pics, but good condition, straight sheet metal, of course with surface rust, but an easy body to work with. This...
Anyone out there who has an MB or GPW engine and want to work a trade for a Kaiser Supersonic engine?
Anyone know where I can find or have any info on the PTO units that mount to the side of a T-18?
Here is a picture of my Dad and his 1947 CJ-2A. The license plate reads 1949. He was making payments of about $27.00 per month on it before he...
Anyone know of an easy way to make a rear flanged 44 into a full floater and still keep the 5 on 5.5 bolt pattern and disc brakes? I do not care...
I figure everyone likes carnage pics. [IMG] [IMG] [IMG]
Well, I broke my rear dana 44 housing nearly in half yesterday. I have all winter to fix it I guess. Since my Detroit locker and gears are pobably...
In my CJ-5 I have a chevy alternator (3 wire). I have an idiot light and a volt gauge on the dash. Problem is that after starting, I have to give...
OK. There is no data plate, and I haven't taken the time to search for numbers under paint. But I believe it is a WWII trailer. I thought it was a...
Got a flat head with water leaving the radiator and entering the block. Replaced head gasket. Motor does not have white smoke. Getting ready to...
Anyone here ever seen a stinger bumper work in somebody's favor? Or do you just roll sideways?
Is there really much difference in various manufacturers of alloy axles? Anyone have good/bad results?
Anyone have any opinion on OX u-joints.
I have always wondered about the overdrive units that people install on Dana 18 cases. I have never seen one and do not know exactly how they...
Anybody know where I can find a '72-'75 Hazard switch? I need the complete assembly. Krage and 4wd Hardware do not show them. If not , does anyone...
Separate names with a comma.