I'm switching my 3-speed Jeepster Commando to an Auto. Can't decide on a TH400 or a TH350. I have the 225 V6. I've read that the TH400 takes 45...
I twisted off the threaded end on one of my rear upper shock mounts. I'd rather not cut the whole mount off and weld on a new one. My...
I've found at least a couple pounds of sand and dirt inside the frame of my '67 Commando (and even a mouse nest). It came from the desert of...
Can anyone list what parts would be needed to switch from the 3-speed to a TH400? I plan on using a buick transmission without the adapter....
I've gotten all the bolts attaching the body to the frame off (had to cut off 4 of the 12). Now I'm ready to remove the body. The front part...
Can anyone tell me if the (side-to-side and wheel-cylinder) steel brake tubes for an early CJ-5 will fit the C101 Commando? What about the...
Has anyone tried "Herm The Overdrive Guy's" Ford power steering conversion on a Commando? I like the fact that the box is behind the...
I understand XJ Cherokee rear shackles fit the front of Commandos (or at least the pre-72 Commando). How about the rears? Do CJ or Wrangler...
Dummy me cannot recall the order of the parts (springs, bushings, etc) for the drag link. Does anyone have a diagram with an exploded view of the...
Does anyone know of a source for a new windshield? Local auto glass doe not have one. Is the glass not the same as a CJ5 or 6?
Can anyone recommend a shop or person(s) that does welding and rust repair on 4X4s? Need the rear floor replaced behind the step-up. Does not...
All, Would you take a look at my "Pics of Commando" post of 8/23 and take a guess as to how much it is lifted? The shackles are the only lift...
If anyone's interested, a few pics of the new Commando. It's a half-cab. Has the bulk-head but not the top. Floors under seats pretty good, bed...
I am rebuilding the fron end on my '67 Commando. It clearly needs a bell crank, numerous tie-rods ends and a new stabilizer. I don't know, but...
My Bell crank is totally shot (as is the drag link). I see that there are a number of bell cranks, ranging from 3/4" to 7/8" to 1.1/8" in...
Separate names with a comma.