You can get Bullnose gas tanks at AutoZone brand new. You will need to use a little ingenuity in mouting the tank but to your 68 but it will work....
I have two NOS power steering engine brackets for the 225. Let me know if your interested. The part numbers are 1378150 for the F16 Jeepster...
I also have a chrome front bumpwer I will sell if your interested.
I have 2 NOS p/s pump brackets for the 225. One is for the F17 smog equipped engine and has the indention for the smog pump and the other is for...
Here are some pics of my 67 fram with power steering without the braces and my 71 frame with the braces. The 67 uses factory hoses but on the 71 I...
I believe the hood is from a 69 model. A friend of mine has a 70 mfd in Sept of 69 and it has the lights in the front fenders instead of the...
You will need to change the yoke on the transfer case to use the new drive shaft (or at least I did). Not sure about the Dana 25/27 driveshaft....
The plugs you speak of under the carb are for carb heat. Most of them are pluged up with carbon deposits. If they are still open the air...
I would do what PackRat advised and start with the voltage regulator. They are not cheap though. Part number VRC-601. Here is the advance auto...
Trailforge makes Sport Bar kits for Jeepsters. http://trailforge.com/commerce/catalog/ I hope the link still works. Join up over at...
Personally I hate Ross stering boxes. I converted all of mine to Saginaw boxes but if you want to keep the originality of it go for it. The box...
That is a Ross steering box and mounts on the frame near the exhaust manifold on the driver's side.
Sorry for the delay. I could not get signed in over the weekend. The parts came from PirateJack.net and the part numbers are as follows. PB7001...
If you want to keep the original look you can buy the single diaphram booster and use your existing master cylinder. I bought one of the single...
Yes. I still have the old booster and master cylinder. I paid around $110.00 plus $12.00 shipping for the booster and master cylinder and another...
I bought a replacement from http://www.piratejack.net/. The 7 inch single diaphram booster PB7001 mounted up to my existing bracket perfectly. I...
I grew up in 67 Jeepster Commando. Learned to drive it when I was 8 and received it as my first car when I was 16. I still have it and drive it...
The front springs worked fine on my 67 but I had to use the 67 shackes since the bracket was indeed too narrow for the 72 spring shackle. If you...
I just finished this swap on my 67. You will need the spring plates from the 72 if you decide not to use the springs but I used the springs like...
I have the 225 V6 and have not had a problem with it overheating. I have not drivien it in an extended trip yet either so time will tell. So far...
Separate names with a comma.